Fillet Weld Break Test

Students observe the operation of a tri-state buffer used in digital electronics. A brief quiz completes the activity.

The learner will understand the structural organization of the SDS and be able to find pertinent safety information using the SDS.

In this simulation activity, an electrician troubleshoots a defective compressor motor that will not start. To find the problem, the learner selects the appropriate blueprints that must be referred to while performing the troubleshooting steps. Then safety protocols will be followed, such as making lockout-tag out installations and donning PPE items before taking measurements with a multimeter to locate the faulty component.

In this interactive object, the learner reads an explanation of how various shielding gases are used in GMAW and FCAW. An exercise completes the activity.

Students view a video that shows the correct methods for starting a GTAW weld pool and adding filler. It focuses on the two problems that many students have – adding filler too soon and angling the torch so that the filler melts prematurely on the filler rod. Note: This activity is 3.6 mb.

In this animated and interactive object, learners follow steps that begin with choosing the correct drive roll and include feeding the electrode wire from the spool to the welding gun.

In this interactive object, learners read an explanation of the electrodes used for welding with the GMAW and FCAW processes. In two matching exercises, students test their knowledge of classification and specification numbers.

Learners view wire feed power sources ranging from 110-volt, single phase units to 460-volt, three-phase units. A description and photos of each are provided.

You'll practice identifying and explaining safe practices for grinding

Review the concepts of safety for Welding