System 1E Review: Steris Low Temp Scope Washer
|
See more in Electronics
Review of the Steris low temp scope washer
Topics of this game:
- This check valve is responsible for assisting in draining
- The max pure filter needs to be replaced every_____ days
- What measures the incoming water temp?
- The minimum reading for the UV light is what?
- What limit switch detects operation of the High pressure pump?
- This solenoid controls the operation of V6
- The minimum incoming water temp needs to be what?
- What switch determines the chamber is full or not?
- The water regulator on the A and B filter assembly is set to what pressure?
- Which device controls the air compressor during the sterile processing cycle?
- How long is the standard drain time?
- What is the first selection that can be changed from the operator changeable values?
- How long is the exposure phase during the sterile processing cycle?
- True or False? The UV clean in place procedure is an acceptable alternative to manual cleaning?
- What is the solenoid that is used for filling the chamber with water?
- How often does the diagnostic cycle need to be performed?
- How long does the system allow for pressure to build to 55 PSI during the max pure filter test?
- Is S1 normally open or closed?
- This monitors the fluid temperature at the outlet of the heater before it enters the chamber
- During the thermocouple test in the DIAG cycle, what is the acceptable temperature difference between TC1 and TC2?
